Installation and operating manual
2.7. Control and display elements
The measured value is displayed on a 4-digit, 7-segment display panel that is also used to configure the device.
2.8. Menu control
The device menu is operated through the miniature push buttons. All settings are stored in EEPROM and thus
remain available even after a power failure.
The stepping speed for the adjustment of the displayed value can be increased by pressing and holding the
respective push button for minimum 5 seconds.
+
After adjusting the parameter value, confirm the entry and exit the respective menu. The new parameter value is
now applied.
10
Area for unit label
mbar
bar
MPa
°C
4-digit 7-segment display
Miniature push buttons
•
Menu >>▲<< UP
•
Increase displayed value
•
Menu >>▼<< DOWN
•
Reduce displayed value
•
Confirm set value
•
Change between configuration and display mode
•
Open selected value
PSI
Pa
hPa
°Ctd
°Ftd
°F
METPOINT
EN
UD01
®