To Remove/Replace Earcups - Arai Helmet RAM-X Operation Instructions Manual

① ②
④
8
③
⑤
A B
A"
B"
C
To install holding arms, first center the screw of the lower bracket on slot
in the shield, being careful to follow the correct angle as illustrated ①.
Pressing the arm and shield together firmly at the lower bracket ②, rotate
both inward to bring the upper shield hook into place as illustrated ③. With
the upper hook and lower bracket in place, slide the arm down until the
upper hook is in place ④ and the curled end of the lower bracket locks into
place as illustrated ⑤.
WARNING:
Confirm that the curled end of the bracket is fully seated between the
shield and arm to prevent the shield and arm from becoming separated
unintentionally.

TO REMOVE/REPLACE EARCUPS

The earcups are secured to their base plates by bosses A , B and C.
C"
To remove earcup, first undo chinstraps, then remove bosses A & B from its
base plate by grasping upper part of earcup on one side and pulling toward
you until a snap is heard, then do the other side of the same earcup.
When both sides are free, push lower part of earcup into the helmet and pull
upward to release tab C.