Installation
NXS-NMS
magnetic
faceplate
FIG. 1
Component locations on both NXC-ME260/64 and NXS-NMS
7. Secure the NXC-ME260/64 faceplate to the NXS-NMS by using a Phillips-head screwdriver to turn
the two faceplate securing screws in a clockwise direction.
8. Connect the 12 VDC power supply to the 2-pin PWR connector and apply power.
Mounting the NXS-NMS Into an Equipment Rack
To install the Master/Hub Module into an optional AC-RK equipment rack:
1. Remove the front panel from the Module to expose the mounting holes.
2. Mount the module on the AC-RK bracket.
3. Place the AC-RK bracket (with the module) in the equipment rack and secure the bracket to the
rack.
4. Replace the front panel to the Module, and reattach the plastic faceplate (if necessary).
Mounting the NXC-ME260/64 in an NXF CardFrame or NXI
The NXC-ME260/64 can be installed in a NetLinx CardFrame (NXF) or NetLinx Integrated Controller
(NXI). In both cases, the card mounts in a horizontal position, through the Master card slot on the rear
panel of the enclosure.
FIG. 2 shows the Master Card slot on the NXF CardFrame.
FIG. 2
Master card slot on rear panel of the NXF CardFrame
6
Program
Master card slot on NXF CardFrame (rear panel)
port
NXS-NMS
Master/Hub Module
NXC-ME260/64 Hardware Reference Guide
NXC-ME260/64
faceplate
NXC-ME260/64
Master card