Nxs-Nms Netmodules; Nxs-Nms Netmodules Specifications; Mounting Modules Into An Equipment Rack - AMX NetLinx NXM Series Operation/Reference Manual

NXF CardFrame and NetModules

NXS-NMS NetModules

The NXS-NMS NetModules (FG2009-10) accommodate one NetLinx Control Card, and connect to the
NetLinx bus via ICSNet connections. The NetModules offer a simple and economical way to integrate
additional functionality to control systems. FIG. 2 shows a NetModule shell and its main components.
front
NXM-NMS
NetModule
ID
rear
FIG. 2 NXS-NMS NetLinx NetModule shell

NXS-NMS NetModules specifications

The table below lists the NXS-NMS specifications.
NXS-NMS NetModules Specifications
Dimensions (HWD)
ID button
Control connector
ICSNet RJ-45 connectors
12 VDC power supply connectors Two parallel male 2-pin (green) parallel connectors for 12 VDC power.
Enclosure
Included Accessories
Optional accessories

Mounting modules into an equipment rack

To install the modules in an equipment rack using the optional AC-RK kit:
1.
Remove the front faceplate from the module to expose the mounting holes.
2.
Mount the module on the AC-RK bracket.
3.
Place the AC-RK bracket (with the module) in the equipment rack and secure the bracket to the rack.
4.
Replace the front faceplate on the module, and attach the translucent plastic cover to the faceplate (if
necessary).
4
20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4
ID Button
1.50" x 5.55" x 9.25" (3.81 cm x 14.10 cm x 23.50 cm)
Generates an event from the NetModule to allow you to assign new
Device and System numbers, using ID mode in the NetLinx Studio soft-
ware program (seeUsing the ID button section on page 5 for details).
20-pin black (male) connector that connects the NetModule to external
devices. These connectors are keyed to insure proper installation.
Receives power and data from a NetLinx Master/Hub ICSNet Port. An
ICSNet port on a NetLinx Master or Hub supplies up to 500 mA at 12 V
for module power.
Metal with black matte finish
NetLinx faceplate
AC-RK Accessory Rack Kit (holds up to three NetModules)
NetModule
3 2 1
12VDC
ICSNet PWR
NetLinx Cardframe, Control Cards, and NetModules
Control Card slot
Control Card connector
(20-pin)
Parallel 12 VDC
2-pin power
supply connectors
ICSNet RJ-45 connectors