Help Menu - AMX NetLinx NI-3101-SIG Operation/Reference Manual

NetLinx Security with a Terminal Connection

Help menu

Type help at the prompt in the Telnet session to display the following help topics:
Help Menu Options
Command
----- Help ----- <D:P:S>
? or Help
DATE
DEVICE HOLDOFF ON|OFF
DEVICE STATUS <D:P:S>
DNS LIST <D:P:S>
DISK FREE
ECHO ON|OFF
GET DEVICE HOLDOFF
GET DUET MEMORY
GET IP <D:P:S>
HELP SECURITY
IP STATUS
MEM
MSG ON|OFF
OFF [D:P:S or NAME,CHAN]
ON [D:P:S or NAME,CHAN]
PASS [D:P:S or NAME]
PING [ADDRESS]
PROGRAM INFO
PULSE [D:P:S or NAME,CHAN]
REBOOT <D:P:S>
RELEASE DHCP
ROUTE MODE DIRECT|NORMAL
132
The FTP Security and Admin Change Password Security are always enabled and cannot be
disabled.
Description
(Extended diag messages are OFF)
<D:P:S>: Device:Port:System. If omitted, assumes Master.
Displays this list.
Displays the current date.
Sets the Master to holdoff devices (i.e. does not allow them to report
ONLINE) until all objects in the NetLinx program have completed
executing the DEFINE_START section.
If set to ON, any messages to devices in DEFINE_START will be lost,
however, this prevents incoming messages being lost in the Master
upon startup. When DEVICE_HOLDOFF is ON, you must use ONLINE
events to trigger device startup SEND_COMMANDs.
By default, DEVICE HOLDOFF is OFF to maintain compatibility with
Axcess systems where f devices are initialized in DEFINE_START.
Provides information about the specified device.
Displays the DNS configuration of a device.
Displays the amount of free space on the disk.
Enables/Disables echo of typed characters.
Displays the state of the Master's device holdoff setting.
Display the amount of memory allocated for Duet Java pool. This is
the current Java memory heap size as measured in Megabytes. An
example is a value of 5 = 5 MB.
Displays the IP configuration of a device.
Displays security related commands.
Provides information about NetLinx IP Connections.
Shows size of the largest block of available memory.
Enables/Disables extended diagnostic messages.
Turns off the specified channel.
Turns on the specified channel.
Puts the Session in pass mode to the specified device.
• Mode is exited by ++ ESC ESC.
• Display Format is set by ++ ESC n
Pings an address (IP or URL).
Specify -a option for reverse lookup.
Displays a list of program modules loaded.
Pulses the specified channel.
Reboots the device.
Releases the current DHCP lease.
Sets the Master-Master route mode.
- If n is A, format = ASCII, D, format = Decimal, and H = Hex
NI-3101-SIG Signature Series NetLinx Integrated Controller