Huawei FusionServer Pro 2488H V6 Technical White Paper page 27

Huawei FusionServer Pro 2488H V6 Server
Technical White Paper
Silkscreen
-
Table 5-4 FlexIO card power indicator and status indicator
FlexIO Card
Power Indicator
(Green)
Off
Steady on
Steady on
Issue 03 (2021-02-01)
Indicator
UID indicator
PSU indicator
FlexIO Card
Status Indicator
(Yellow)
Off
Off
Blinking at 2 Hz
Copyright © Huawei Technologies Co., Ltd.
5 Hardware Description
Description
The UID indicator helps identify and
locate a device.
● Off: The device is not being located.
● Blinking or steady blue: The device
is being located.
NOTE
You can control the UID indicator status by
pressing the UID button or using the iBMC.
● Off: No power is supplied.
● Blinking green at 1 Hz:
– The input is normal, and the
server is standby.
– The input is overvoltage or
undervoltage.
– The PSU is in deep hibernation
mode.
● Blinking green at 4 Hz: The
firmware is being upgraded online.
● Steady green: The power input and
output are normal.
● Steady orange: The input is normal
but there is no output.
NOTE
The possible causes of no power output
are as follows:
● Power supply overtemperature
protection
● Power output overcurrent or short-
circuit
● Output overvoltage
● Short-circuit protection
● Device failure (excluding failure of
all devices)
Description
The FlexIO card is not detected.
The FlexIO card is detected and
operating properly.
The FlexIO card is being hot-swapped.
20