Switching Lighting Modes; Cruiser Headlight - Cycle Torch Cruiser User Manual

4

CRUISER HEADLIGHT

Switching lighting modes

OPERATION MODES
The initial short press of the Power Button
will turn ON the light in High mode. Each
additional short press of the power button
switches the light from one mode to the
next in the following order:
Operating modes:
Run time (in hours)
Power (in lumens)
TURNING OFF CRUISER
Press and hold the button for one
to three seconds.
CHECKING BATTERY LEVEL
When CRUISER is turned OFF, press the button
for 3 seconds and release. The light will flash
from 1 to 10 times indicating the battery level
remaining (10 flashes indicate - 100% charge,
9 flashes - 90%, 8 flashes – 80%, 7 flashes – 70%).
It is strongly recommended to recharge Cruiser when there is less than
20% load (see: check the battery charge level). Do not wait until the light goes
completely out as this will greatly reduce the number of charge cycles that the
battery can be used and can render the battery unusable.
Charge your bike light every 2-3 months when stored or not in use to prevent
battery degradation.
CRUISER USER MANUAL
High Medium Low
2 4 20
200 100 20
1 High
2 Medium
3 Low
4
Flash
5 Pulse
Flash Pulse
40 40
200 200
LOW BATTERY LEVEL
CRUISER will automatically turn OFF when the
battery level is too low. This system protects the
battery from damage, but since it draws a small
amount of current, it can drain the battery beyond
the minimum voltage for the battery.
Operation/
Power button
6