Switching The Lighting Modes; Model Specifications - Cycle Torch Tail Bolt User Manual

IV. Switching the lighting modes
Operation Modes: Short press of the operation button will switch through
cycles & shut down the Tail Bolt. The initial short press of the power button will turn
on the light on High mode. Each additional short press of the button switches the
light from one mode to the next, in the following order: (1) High; (2) Slow flashing;
(3) Quick flashing; (4) Pulse; (5) OFF.
Operating modes:
Run time (in hours)
Power (in lumens)
Low Battery Level: The Tail Bolt will automatically turn off when the
battery level is too low. This system protects the battery from damage, but since
it draws a small amount of current, and can drain the battery beyond the
minimum voltage for the battery, so it's not recommended to turn ON the lights
after the programmed shutdown.
Do not wait until the Tail Bolt goes completely out as this will greatly
reduce the number of charge cycles that the battery can be used and can
render the battery unusable. It is highly recommended to recharge periodically
the Tail Bolt.
Charge your bike light each 2-3 months when stored or not in use to
prevent battery degradation.
V. Model Specifications
 Model range: Tail Bolt
 Water-resistant rear tail light brightness: 10 LM
 Waterproof Grade: IP65
 Light Source: 3535 LED ultra lumineux
 LED lifespan: 50,000 hours
 Low power consumption
Slow
High
flashing
2 15-20
10 10
5
Quick
Pulse
flashing
10-15 10-15
10 10