Switching The Lighting Modes; Model Specifications - Cycle Torch MicroBot User Manual

IV. Switching the lighting modes
Operation Modes: Short press of the power button will switch through cycles
& shut down the MicroBot. The initial short press of the power button will turn on
the light on High mode. Each additional short press of the power button switches
the light from one mode to the next, in the following order: (1) quick flash; (2) slow
flash; (3) circular flash quick; (4) circular flash slow; (5) steady; (6) OFF.
To turn off the MicroBot, press and hold the power button for about three
seconds.
Operating modes:
Run time (in hours)
Power (in lumens)
Low Battery Level: The MicroBot will automatically turn off when the
battery level is too low. This system protects the battery from damage, but since
it draws a small amount of current, and can drain the battery beyond the
minimum voltage for the battery.
Do not wait until the MicroBot goes completely out as this will greatly
reduce the number of charge cycles that the battery can be used and can
render the battery unusable. It is highly recommended to recharge periodically
the MicroBot.
Charge your bike light each 2-3 months when stored or not in use to
prevent battery degradation.
V. Model Specifications
 Model range: MicroBot
 Water-resistant rear tail light brightness: 25 LM
 Waterproof Grade: IP65
 Light Source: 3 x 3535 LED ultra lumineux
 LED lifespan: 50,000 hours
 Low power consumption
quick flash slow flash
6 9
25 25
5
C.F. quick C.F. slow
10 14
10 10
steady
1,5
25