How To Charge - Cycle Torch Cruiser User Manual

3

How to Charge

CRUISER HEADLIGHT
1
1
Remove the rubber cap
at the bottom of the light;
BOLT TAIL LIGHT
1
1
Remove the rubber cap
at the bottom of Bolt;
TIPS AND TRICKS:
• When your PC is in sleep state, the light cannot be charged;
• Flashing light of the power button shows that a charging error has occurred. Remove and reinsert
the USB cable, then begin the recharge process again;
• The battery charges to about 80% after approximately 2 hours;
• Charging and lighting times are approximate values and will vary by environmental and user conditions.
The cable (or other accessories) supplied with the Cycle Torch bike lights MUST be
used only to charge the Cycle Torch bike lights. The Manufacture or/and the Seller
are not responsible for any damage caused by using the supplied accessories with
devices other than Cycle Torch bike lights.
WARNING
WARNING
CRUISER USER MANUAL
2
2
Connect the light to your PC, or
a 5V max 2A USB battery char-
ger with the USB cable. A LED
indicator lights up red signaling
the charging has started.
2
2
Connect the Tail Bolt to your PC
or a 5V max 2A USB battery char-
ger with the USB cable. The lens
lights up red when the charging
starts;
3
3
ÿ
When the LED indicator turns
blue, charging is complete.
Remove the USB cable.
3
3
When the lens lights up green
- charging is complete. Remove
the USB cable;
Charging time: 2 hours
5