Switching The Lighting Modes; Model Specifications - Cycle Torch Fire stick User Manual

IV. Switching the lighting modes
Operation Modes: The initial short press on the power button turns on the Fire
Stick. The light will light on the last used mode.
Two short presses on the power button will switch the light between the Flash
Mode and the Steady Mode. Each additional short press on the button switches the
light's intensity in the following order: (1) High; (2) Medium; (3) Low.
To turn off the Fire Stick, press and hold the power button for about three
seconds.
Operating modes:
Steady Mode run time (in hours)
Flashing Mode run time (in hours)
Power (in lumens)
Low Battery Level: The Fire Stick will automatically turn off when the
battery level is too low. This system protects the battery from damage, but since
it draws a small amount of current, and can drain the battery beyond the
minimum voltage for the battery.
Do not wait until the Fire Stick goes completely out as this will greatly
reduce the number of charge cycles that the battery can be used and can
render the battery unusable. It is highly recommended to recharge periodically
the Fire Stick.
Charge your bike light each 2-3 months when stored or not in use to
prevent battery degradation.
V. Model Specifications
 Model range: Fire Stick
 Water-resistant rear tail light brightness: 50 LM
 Waterproof Grade: IP65
High Medium
3 6
6 15
50 25
5
Low
15
25
10