AMX NXD-CV7 Operation/Reference Manual page 39

Panel Interface
connector (male)
Front
Securing
pegs (2)
FIG. 28 NXA-BASE/1 showing Panel Interface and connector locations
4. Carefully angle the NXT-CV7 panel over the front alignment pegs (FIG. 29). The pegs assist in both
aligning and securing the panel to the base (the locking mechanism secures the base to panel when
done).
Alignment
pegs
FIG. 29 NXA-BASE/1 shown aligning with NXT-CV7 panel
5. Insert the alignment pegs into their corresponding holes below the front of the panel.
6. Verify the alignment of the Panel Interface connectors between the panel (female connector) and
base (male connector) (FIG. 29).
7. Align the rear pegs and gently push the rear of the panel downwards until it is mounted atop the
battery base.
The battery base CANNOT be hot-swapped. An NXT can not be receiving power
(through a connected power supply) and then be connected to a battery base.
Always POWER OFF the panel before installing the NXA-BASE/1.
8. Slide the rear battery locking slider in the opposite direction. This turns the latching mechanism and
secures the panel to the base.
9. Upon successful connection, the AMX logo appears on the panel to indicate that the panel is
properly connected and receiving power.
7" Modero Widescreen Touch Panels
Alignment
pegs (2) Back
CV7 Touch Panel Accessories
Battery
locking
mechanism
Battery
locking slider
(Battery not shown
for illustration purposes)
Insert holes for
NXT-CV7 feet
Battery
locking
mechanism
(with locking
slider)
29