Startup - AMX NXD-CA12 Installer's Manual

Using NetLinx Studio
1. Launch Windows Explorer, and navigate to the directory where your Design XPress project is
located.
2. Locate and select every TXT file in the project folder. Be sure to select every TXT file, and
only TXT files.
3. Copy the files to clipboard memory (right-click on the selection and select Copy).
4. Launch Internet Explorer.
5. In the Address box, enter FTP://, followed by the IP Address of the Master, and press Enter.
6. Assuming the IP Address was entered correctly, and the Master is connected properly, you are
presented with a dialog prompting you to enter the User Name and Password for the Master.
7. Enter the User Name and Password, and click the Log On button. Once you are logged on to
the Master, you should see directories associated with your Design XPress project.
8. Paste the copied TXT files into the root of this directory. Do not paste them into a folder or
create a new folder for them; they must reside at the root.
9. Reboot the Master.

Startup

Once the master boots up, give it a minute or two to become completely operational. If there are a
large number of devices it could take up to two minutes. This is due to the large amount of message
traffic as devices come online. DMS keypads must have their menus loaded during this time as
well.
14
The default User Name is administrator
The default Password is password.
DMS Keypads will display the message "Master Found Wire Is Good." when the roboot
is nearing completion, and will display the Main Page when the reboot is complate.
Touch Panels will beep twice to indicate that the system is fully operational.
Design XPress Installer's Guide