Before Operation - Mitsubishi Electric CP-D70DW Service Manual

BEFORE OPERATION

PRINTER SETUP PROCEDURE
Before printing, follow the printer setup listed below.
Position the adjustable paper guides.
Install the print paper to this printer.
Install the ink ribbon to this printer.
Connect the printer to a personal computer.
For CP-D707DW, setting up procedure in the frame is required for each printing unit.
Make sure to close the printing unit when the setup procedure is completed.
BEFORE OPERATION
Adjust the paper guides according to the paper width.
(See page 10.)
For 9x13(3.5x5") or 13x18(5x7")
(See pages 11 to 12.)
size paper (5"-width)
(See pages 13 to 14.)
HOW TO SET THE ADJUSTABLE PAPER GUIDES
Pinch the tab on the adjustable paper guide and slide it right or left.
(See page 16.)
Slide the paper guide until it stops. The paper guide will snap into place.
Slide other paper guide in the similar way.
Make sure to set the adjustable paper guides to the size of the paper width. When they are not positioned properly, a
malfunction such as paper jam and misaligned printing position may occur.
Do not use 10x15 (4x6") or 15x20 (6x8") size paper (having width of 152 mm) after using 9x13 (3.5x5") or 13x18 (5x7")
size paper (having width of 127 mm) for a long time or printing such paper in large quantities.
9
POSITIONING OF ADJUSTABLE PAPER GUIDE
Adjustable paper guides
For 10x15(4x6") or 15x20(6x8")
size paper (6"-width)
Tab
NOTE
NOTE
10