Westcott RING LIGHT KIT Quick Start Manual

18"

Advertisement

Quick Links

18"
RING LIGHT KIT
QUICK START GUIDE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RING LIGHT KIT and is the answer not in the manual?

Questions and answers

Summary of Contents for Westcott RING LIGHT KIT

  • Page 1 18" RING LIGHT KIT QUICK START GUIDE...
  • Page 2 Components (1) 18" Ring Light (1) Power Supply (2) NP-750 Batteries (1) Battery Charger (1) Mobile Device Mount (1) Gooseneck Arm with 1/4"-20 Thread (1) Swivel Mount with 1/4"-20 Thread (1) 5.75' Light Stand (1) Carry Case Cold Shoe Mounts Dimming 1/4-20"...
  • Page 3 Warning • Only use with the included AC power supply and power cord. • Only use with NP-F Series batteries of the same capacity (Voltage Range: 7.4V-12V). • Both batteries should have the same state of charge when mounted. Avoid using a fully-charged battery and a partially depleted battery at the same time.
  • Page 4 Basic Operation AC Ring Light Operation 1. Ensure the Ring Light is OFF by moving the power selector to the middle position [O]. 2. Connect the included AC power supply and power cord. 3. Insert the AC power supply’s barrel plug into the AC receptacle on the back of the Ring Light.
  • Page 5 Available Modes Pressing the dimming knob down continuously will cycle the Ring Light through three different modes: Light Output, Color Temperature, and Battery Status. Light Output By default, the Ring Light will start in the Light Output Mode and the LED indicator square next to the “BRT” will illuminate. While in Light Output Mode, turn the dimming knob to adjust the light output level from low (P-00) to high (P-100).
  • Page 6 Warranty Period, at its option and to the extent permitted by law, Westcott will either (1) repair the defect at no charge, using new or refurbished replacement parts, or (2) exchange the product with a product that is new or which has been manufactured from new or serviceable used parts and is at least functionally equivalent to the original product.

Table of Contents