Start-Up; Switching On / Off; Selecting The Unit Of Length - Parkside 20 M PLEM 20 A4 Operation And Safety Notes

Start-up



Switching on / off

To switch the product on, press the MEAS button
When the product is switched on, the laser beam is activated.
To switch the product off, press and hold the MEAS button
for approx. 5 seconds until the "OFF" is shown on
4
display
3
product turns off automatically to save the batteries.
To switch measuring reference point: Press the reference /
unit button
side of the product to its bottom side or vice versa.

Selecting the unit of length

1. Press and hold the REF/UNIT button
3 seconds.
2. The unit will change on the display
3. Repeat the step 1 until the desired unit appears on the
display .
3
Note: Following units of length are available:
m meter
feet / inches
in inch
ft foot / feet
. If no button is pressed for about 3 minutes, the
to change measurement base from the top
5
for more than
5
.
3
.
4
GB 13