Lubrication; Greasing The Machine - Toro TITAN MAX 76601 Operator's Manual

Maintenance Service
Interval
Every 500 hours
Monthly
Yearly or before storage
Important:
Refer to your engine owner's manual for additional maintenance procedures.
CAUTION
If you leave the key in the switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Shut off the engine and remove the key from the switch before you perform any maintenance.

Lubrication

Greasing the Machine

Grease the machine more often in dirty or dusty
conditions.
Grease Type: No. 2 lithium or molybdenum grease
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings with a rag.
Note:
Scrape any paint off the front of the
fitting(s).
4. Connect a grease gun to the fitting.
5. Pump grease into the fittings until grease begins
to ooze out of the bearings.
6. Wipe up any excess grease.
Maintenance Procedure
• Replace the spark plugs and set the gap.
• Check the parking brake adjustment.
• After the initial change—change the hydraulic-system filters and fluid when using
Toro® HYPR-OIL™ 500 fluid. (Change it more often under dirty or dusty conditions)
• Check the battery charge.
• Paint chipped surfaces.
• Complete all the procedures in the Storage chapter.
32