Whirlpool WVH92K W Instructions For Use Manual page 76

Reset filter saturation
After performing maintenance on the filters (greases and/or
carbon/ceramic), press and hold "
" "(13) turns off, restarting the indicator count.
Activation filter saturation indicator
This indicator is normally deactivated.
To activate it, proceed as follows:
- turn on the extractor hob via
- with the extraction motor and cooking zones off, press the
Selection zone (12)
HOOD
- long press " " (11) until the letters "F" – "G" appear
alternately flashing in the Display (12)
F = carbon/ceramic odour filters
G = grease filter
Carbon/ceramic odour filters
−
press on the Display (12) when the letter "F" appears
−
press " " (13) – flashing light
HOOD
−
long press "
activation of the carbon/ceramic odour filter indicator
Grease filter
−
press on the Display (12) when the letter "G" appears
−
press " " (13) – fixed light
HOOD
−
long press " " (11) again to confirm activation of
the grease filter indicator
" (13) ;
;
" (11) again to confirm the
The device can also be used in combination with a
Window sensor KIT (not supplied by the manufacturer).
If the Window sensor KIT is installed (only in the case of use
in EXTRACTOR mode), air extraction will stop working each
time the window in the room, on which the KIT is applied, is
closed.
-The KIT must be electrically connected to the device by
qualified and specialised technical personnel.
-The KIT must be separately certified in accordance with
the safety standards relative to the component and its
use with the device. Installation must be carried out in
accordance with current regulations for domestic
systems.
CAUTION:
-the wiring of the KIT to be connected to the device must
be part of a certified safety extra low voltage (SELV)
circuit.
-the manufacturer of this device declines all liability for
any inconveniences, damage, fires caused by defects
and/or problems associated with malfunction and/or
incorrect installation of the KIT.
76