Electrical Connection - Whirlpool WVH92K W Instructions For Use Manual

MOUNTING
Before starting the installation:
• After unpacking the product, check that it has not been damaged during transport and in the case of problems, contact
your dealer or Customer Service, before proceeding with the installation.
Check that the product is the right size for the installation location.
•
• Check for accessories inside the packaging (placed there for ease of transport) such as bags containing screws, the warranty
card, etc.. Remove them and keep them safe.
Also check that there is a power socket near the installation area
•
Preparing the cabinet for installation:
- The product cannot be installed above cooling appliances, dishwashers, heaters, ovens, washing machines and dryers.
- Cut the cabinet before inserting the hob and carefully remove shavings or sawdust.
- to optimise the filter installation, it is advisable to cut a slot in the plinth to insert a grille (available on the market)
IMPORTANT: use a single component adhesive sealant (S), resistant against high temperatures up to 250°;
prior to installation, the surfaces that need to be glued must be carefully cleaned, removing all substances that may compromise
adhesion
(e.g. release agents, preservatives, grease, oils, powders, old adhesive residue, etc.);
the sealant must be evenly distributed along the entire perimeter of the frame;
after gluing, leave to dry for approximately 24 hours.
CAUTION! Failure to install screws and fasteners in accordance with these instructions may result in electrical hazards.
Note: to ensure the correct installation of the product, it is recommended to tape the pipes using an adhesive with the following
characteristics:
- soft elastic PVC film, with an acrylic-based adhesive
- which complies with DIN EN 60454 regulations
- flame retardant
- excellent resistance against wear
- resistant against temperature fluctuations
- can be used in low temperatures

ELECTRICAL CONNECTION

Fig. 3
- Disconnect the device from the electrical network
-The installation must be performed by professionally qualified personnel familiar with the applicable installation and safety
standards.
-The manufacturer declines any liability to people, animals or things in the case of failure to follow the guidelines provided in this
chapter.
-The power cable must be long enough to allow removal of the hob from the worktop
-Make sure that the voltage on the rating plate on the bottom of the device corresponds to that of the house where it will be installed.
-Do not use extension cords.
- Earthing is required by law
- The earth power cable must be 2cm longer than the other cables
- If the household appliance is not equipped with a power cable, use one with a minimum conductor diameter of 2.5 mm2 for power
up to 7200 Watt; for higher power levels, the diameter must be 4 mm2.
- At no point along the length of the cable must it reach a temperature of 50° C above the room temperature.
- The device is intended to be permanently connected to the electrical network, therefore, make the connection to the fixed network
via a standard omnipolar switch, which assures the complete disconnection of the mains under category III over-voltage conditions,
and which is readily accessible after the installation.
Fig. 3b/3c
Note: to connect the appliance using the optional single phase connection the existing cable must be removed and
replaced with another type (not supplied) having the following specifications:
single phase connection: H05V2V2-F 3G4 cable
Fig. 3a
Caution! Before reconnecting the circuit to the mains power supply and checking its correct operation, always check that the
network cable has been correctly assembled.
Caution! The interconnection cable must be replaced by authorised customer service personnel or equally qualified person.
Note : the product is equipped with a Power Limitator function, which allows a maximum power limit to be set
The limit must be set at the time of the product's connection to the electrical network or when the electrical network itself is
reconnected (within the following 2 minutes). For the Power Limitation setting sequence, see the Operation section of this
manual.
69