Whirlpool WVH92K W Instructions For Use Manual page 75

then scroll on the Selection bar (3), until the symbols
" "
8 ,appear
the Display (2-FL) will show the current setting**
0 = 7.4 KW
1 = 4.5 KW
2 = 3.1 KW
** by default the setting is 7.4 KW
To change the Power Limitation setting
- press the Display (2) of the left front area (FL)
- then scroll on the Selection bar (3), to select the new setting
- to save the choice made, press the
seconds; a prolonged audible signal will be emitted to confirm
the successful setting
USING THE EXTRACTOR FAN
Switch-on
Press (touch) briefly
continuing to press, all the available functions will become
visible for a few moments, e, after which only the main
ones will remain active; the others can be used, and will
be activated, subsequently, during use of the device.
IMPORTANT:
all the available functions will be illuminated with light
intensity, which will become more intense only when they
are activated.
Press again to turn off
Note: This function has priority over the others.
Starting the extractor:
Touch (press) the Selection zone (12) to activate the
extractor
Extraction speed (power):
The extractor is equipped with 3 levels of extraction speed
(power)
Touch and slide your fingers along the Selection bar (3):
to the right to increase the level of power;
to the left to decrease the level of power.
The power level set will be displayed in the
Selection/Display area (12)
"
(1), for 2
(1) hob/extractor;
Power Booster
"
C and
The product has 2 additional power levels (above level 3)
−
Power Booster 1 : timed for 15 min.
−
Power Booster 2 : timed for 5 min.
after which the power returns to the previously set level.
Touch and slide with the fingers along the Selection bar (3)
(over level 3) and activate the Power Booster 1
The Power Booster level 1 is indicated in the Selection /
Display area (12) with the number "4" flashing
Touch and slide with the fingers along the Selection bar (3)
(over level 3) and activate the Power Booster 2
The Power Booster level 2 is indicated in the Selection /
Display area (12) with the symbol" " flashing
Automatic operation
The hood will turn on at the most suitable speed, adapting the
extraction capacity to the maximum cooking level used in the
cooking zone.
When the cooking zones are switched off, the hood adapts its
extraction speed, decreasing it gradually, to eliminate residual
vapours and odours.
To activate this function:
Press
Repeat the operation to deactivate.
Note: if during automatic operation are selected from the
Selection bar (3) the speeds from 1 to 3, the automatic
operation is interrupted;
if, instead, the Power Boosters are selected, automatic
operation will resume at the end of the timing, while in the
meantime the symbol "
Note: if the hob automatically shuts down with Automatic
mode active, the extractor fan will automatically turn off in a
gradual manner.
Filter saturation indicator
The hood indicates when filter maintenance is needed:
Carbon/ceramic odour filters
" "(13) comes on
Grease filter
" "(13) flashes
Note: this function is disabled by default (see how to
enable it in the paragraph "Activation filter saturation
indicator")
75
(14)
" remains flashing.