Advertisement
Allow the mixer to cool for approximately
30 minutes. Once the motor is fully cooled,
it is ready for use again. Do not operate the
mixer continuously with an excessive load
for more than 3 minutes. To reduce the risk of
overloading, remove some of the mixture and
process in smaller batches.
USING THE ATTACHMENT HUB
IMPORTANT
Attachments that require the use of the
hub for this mixer are sold separately. Only
attachments specifically designed for this
mixer (Model LEM750) may be used.
Never use accessories and hub attachments
(sold separately) other than those specifically
designed or specified with this bench mixer.
NOTE
Never operate any of the hub attachments
whilst using the bench mixer accessories at the
same time.
1. To remove the magnetic attachment hub
cover, push on the bottom half of the cover
so that the top half pops out, then remove
and store safely.
2. Ensure the chosen attachment is fully
assembled before connecting to the
attachment hub. Refer to the individual
attachment instruction booklet for how to
assemble and attach to the bench mixer
attachment hub, as each hub attachment
may be different.
LEM750_ANZ_IB_A20.indd 17
3. Once the attachment is fully assembled on
the attachment hub, refer to the individual
hub attachment instruction booklet for food
preparation, functions and operation. Turn
the speed control dial to the appropriate
setting, based on the attachment used, or
found in the table titled 'Hub Attachments'
following:
Hub Attachments
COMPATIBLE
ATTACHMENTS
LEM012 – the Pasta Chef™
Roller Attachment
LEM013 – the Spiralizer
Chef™ Attachment
LEM014 – the Food
Processor Chef™
Attachment
NOTE
After use, always remove the hub attachment,
clean and store separately.
4. Once the task is complete, turn the speed
control dial to the OFF (0) position. Press
the hub attachment release button to
remove the attachment from the mixer hub.
5. Refer to the individual attachment
instruction booklet for information on
assembling, disassembling, the attachment,
care, cleaning and storage.
6. Replace the attachment hub cover by
aligning the bottom grooves of the
attachment hub cover with the bottom of
the attachment hub and lightly push the
cover in. The magnetic pull will secure the
attachment cover in place.
Speed/Setting
on Control Dial
1-4
1-4
1-4
17
5/8/20 12:37 pm
Hide quick links:
Advertisement
