Table 3.1 List Of Ups Weights - Mitsubishi Electric 9900D Series Owner Technical Manual

Uninterruptible power supply system

Hide thumbs

Table Of Contents

Table of Contents

CABINET ANCHORING

All cabinets shall be securely anchored to the foundation with bolts or anchoring lugs. It is the

responsibility of the customer to size such anchoring. All mounting holes and the correct sizes of

mounting hardware and fasteners shall be used. Other means of anchoring the cabinets (e.g. welding,

adhesives, etc.) shall not be used without prior approval from Mitsubishi Electric.

CONTACT WITH FOUNDATION

The cabinet mounting shall be inspected to ensure that the cabinets are resting solidly on the

foundation by inserting a feeler gauge no thicker than 0.005 inches (0.127 mm) between the foundation

and all base channel. If the feeler gauge cannot be inserted within 2 inches of the edge of each

mounting hole, the cabinets are resting solidly on the foundation. If the feeler gauge can be inserted,

steel shims shall be inserted within 2 inches of each side of every base channel mounting hole to

maintain contact between the cabinet and foundation at all points. Refer to Figure 3.5 for shim contact

around the mounting holes on the base channel.

Figure 3.5 Shim contact around mounting holes on the base channel. (Bottom View)

STEEL SHIMS

Use smallest number of shims possible, but no more than four (4). Shims shall be flat and straight, free

from burrs, slag, or dents. If shims are bent, damaged, rusty, or otherwise deformed, they shall not be

used. Shims shall be able to bear the weight of the supported item without deforming or becoming

thinner over time. Always use the thickest shims possible to minimize number of shims used. Before

reusing shim stacks, they should either be cleaned or new shims should be used.

UNIT WEIGHT AND CLEARANCES

A) Note the load tolerance of the floor

Refer to Table 3.1 for list of UPS weights.

UPS Capacity (kVA)

Weight (lb.)

9900D SERIES UPS

OWNERS / TECHNICAL MANUAL