Download Print this page
Mercia Garden Products 01COMGRN0406-V1 General Instructions Manual

Mercia Garden Products 01COMGRN0406-V1 General Instructions Manual

4x6 greenhouse shed

Advertisement

Quick Links

General Instructions
01COMGRN0406-V1 - 4x6 Greenhouse Shed
8x6 Greenhouse with shed.
10x6 Greenhouse with shed.
12x6 Greenhouse with shed.
BEFORE YOU START PLEASE READ INSTRUCTIONS CAREFULLY
- Check the pack and make sure you have all the parts listed.
- When you are ready to start, make sure you have the right tools at hand (not supplied) including a Phillips
screwdriver, Stanley knife, Wood saw, Step ladder, Hammer and a Drill with 2mm bit.
- Ensure there is plenty of space and a clean dry area for assembly.
TIMBER
As with all natural materials, timber can be a ected during various weather conditions. For the duration of
heavy or extended periods of rain, swelling of the wood panels may occur. Warping of the wood may also
occur during excessive dry spells due to an interior moisture loss. Unfortunately, these processes cannot be
avoided but can be helped. It is suggested that the outdoor building is sprayed with water during extended
periods of warm sunshine and sheltered as much as possible during rain or snow.
Once your garden building has been installed it will need to be treated as soon as possible and annually to
prevent the timber from deteriorating and to waterproof it. This is required to maintain the anti-rot guaran-
tee.
Dip Treated buildings - Require a preservative treatment to protect against rot and decay and a waterproof
treatment to prevent water ingress
Pressure Treated buildings - Require a waterproof treatment to prevent water ingress
Log Cabins - Are supplied untreated and require a preservative and waterproo ng treatment.
BUILDING A BASE
When thinking about where the building and base is going to be constructed:
Ensure that there will be access to all sides for maintenance work and annual
treatment.
Ensure the base is level and is built on rm ground, to prevent distortion. Refer to diagrams for the base
dimensions, The base should be slightly smaller than the external measurement of the building, i.e. The
cladding should overlap the base, creating a run o for water. It is also recommended that the oor be at
least 25mm above the surrounding ground level to avoid ooding.
TYPES OF BASE
- Concrete 75mm laid on top of 75mm hard-core.
- Slabs laid on 50mm of sharp sand.
Whilst all products manufactured are made to the highest standards of Safety and in the case of
childrens products independently tested to EN71 level, we cannot accept responsibility for your safety
whilst erecting or using this product.
Refer to the instructions pages for you speci c product code
Please retain product label and instructions for future reference
x2
All building's should be
erected by two adults
For ease of assembly, you
MUST pilot drill all screw
holes and ensure all screw
heads are countersunk.
2mm Drill bit
For ease of assembly, you
will need a tape measure to
check dimensions of
components.
**Protim Aquatan T5 (621)**
Your building has been treated with Aquatan.
Aquatan is a water-based concentrate which is diluted with water, the building as been treated by the correct
application of Aquatan solution and then allowed to dry.
Aquatan is a decorative nish to colour the wood, which is applied industrially to timber fence panels and
garden buildings.
Aquatan undiluted contains: boric acid, sodium hydroxide 32% solution, aqueos mixture of sodium dioctyl
sulphosuccinat and alcohols: 2, 4, 6-trichlorophenol.
For assistance please contact customer care on: 01636 880514
Mercia Garden Products Limited,
Sutton On Trent,
Newark,
Nottinghamshire,
NG23 6QN
www.merciagardenproducts.co.uk
Winter = High Moisture = Expansion
Summer = Low Moisture = Contraction
CAUTION
Every e ort has been made during the
manufacturing process to eliminate the
prospect of splinters on rough surfaces of the
timber. You are strongly advised to wear gloves
when working with or handling rough sawn
timber.
P 1

Advertisement

loading
Need help?

Need help?

Do you have a question about the 01COMGRN0406-V1 and is the answer not in the manual?

Questions and answers

Summary of Contents for Mercia Garden Products 01COMGRN0406-V1

  • Page 1 General Instructions Please retain product label and instructions for future reference All building’s should be Winter = High Moisture = Expansion 01COMGRN0406-V1 - 4x6 Greenhouse Shed erected by two adults Summer = Low Moisture = Contraction 8x6 Greenhouse with shed.
  • Page 2 01COMGRN0406-V1: Plus 8x6, 10x6 & 12x6 Greenhouse with shed. Please retain product label and instructions for future reference 4x6 Shed 8x6 Greenhouse with shed Overall Dimensions: Overall Dimensions: Width = 1972mm Width = 1972mm Depth = 1299mm Depth = 2447mm...
  • Page 3 Please retain product label and instructions for future reference Step 2 Step 4 Place the oor (No. 4) onto a Following the same method rm and level surface. outlined in Step 3 place the second plain panel and Ensure your base has suitable assembled door gable onto drainage and is free from the oor and x at each corner...
  • Page 4 Please retain product label and instructions for future reference Step 6 Step 8 Attach an eaves frame (No. 8) to one Place a cover trim (No. 9) edge of each roof sheet (No. 5) using at each corner of the 4x30mm screws per roof.
  • Page 5 Please retain product label and instructions for future reference Step 10 Step 9 **If attaching a greenhouse move onto Cut the felt into three strips and lay Step 11.** onto the as shown in the illustration. Secure the fascia’s (No. 10) and the nial’s *Ensure there is approximatley (No.
  • Page 6 Please retain product label and instructions for future reference **Please note: This product can be be erected with the shed door either inside the building (internal) or Step 12 (internal) outside (external). Before beginning assembling, decide which con guration best suits your needs and read through both sets of instructions carefully.** Place the two window panel(s) onto the base frame (See Step...
  • Page 7 Please retain product label and instructions for future reference Step 13 (internal) Step 15 (internal) Following the same method Place the window into the roof and outlined in Step 12, rest the secure into position using 6x16mm 30mm door side panels onto the screws and 6x30mm screws as 16mm assembly and secure into...
  • Page 8 Please retain product label and instructions for future reference Step 16 (internal) Step 18 (internal) Fix the casement stay to the Using the roof’s as a guide, mark the window using 20mm screws position for the roof block (No. 12) at as shown in the ilustration.
  • Page 9 Please retain product label and instructions for future reference Step 19 ( i nternal) Step 20 (internal) With the roof block in place, Attach the roof support bar - See greenhouse instructions position the roof’s onto the 16x50mm Screws assembly ensuring they rest to the roof panels using 40mm on top of the gable top and screws.
  • Page 10 Please retain product label and instructions for future reference Step 22 ( i nternal) Attach the fascia’s from the It is ESSENTIAL that you apply wood greenhouse - See greenhouse treatment immediately after the building instructions - to the front of the has been assembled.
  • Page 11 Please retain product label and instructions for future reference Instructions: External shed door option. Step 25 (external) Attach the last two cover strips Step 23 (external) (No. 9) to the back gable of the greenhouse using 3x30mm Follow these instructions to Step 10 screws per strip.
  • Page 12 Please retain product label and instructions for future reference Step 26 (external) Step 27 (external) Once both buildings have been Attach the fascia’s from the erected, secure the greenhouse greenhouse - See greenhouse to the shed section by screwing instructions - to the front of the through the back of the building using 6x40mm screws.
  • Page 13 Please retain product label and instructions for future reference Step 28 (external) It is advisable to seal around all window framing with silicone sealant (not included) to minimize water ingress. *Please note: This image is for illustrative purpose and may di er from your product (in regards to the number of windows) however the principle...