Clock Setting - THOMSON MIC215i Manual

SYSTEm CONNECTIONS
Speaker connections
Connect one speaker to the R terminal and the other
speaker to the L terminal.
Note: Connecting speakers other than the speakers
supplied with the unit may damage the unit.
using the AC Adaptor
Using an AC adaptor other than the one supplied with the
unit may damage the unit.

ClOCK SETTING

Setting the clock can only be done in STANDBY mode.
• Press and hold the mEm/
• Tap the 7 or 8 button to adjust to the desired hours then tap the
mEm/ button once to confirm. The minute digits will begin to
blink.
• Tap the 7 or 8 button to adjust to the desired minutes then
tap the mEm/ button once to start clock.
Note:
In any mode, press the DISPlAY button, the current time will be shown on the display.
MICRO SYSTEM
MIC215i
To D C IN jack
FM antenna
button until the hour digits blink.
CAuTIONS:
• Before use, ensure the rated voltage of the adaptor
matches your local voltage.
• The included AC adaptor is for use with this unit only.
Do not use it with other equipment.
• If you are not going to use the unit for a long time,
disconnect the AC adaptor from the wall outlet.
• Whenever the AC adaptor is plugged in to a wall outlet,
electricity is running through the unit, even when the
power switch is turned off.
Fm ANTENNA
Do not connect the FM antenna to an outside antenna.
A C
adaptor
USING
To A C
outlet
15 EN