Haier HD90-A2979 User Manual page 6

1-Safety information
WARNING!
Maintenance / cleaning
Clean the lint filter and the condenser fi lter after each pro-
gramme (see CARE AND CLEANING).
Do not use water spray or steam to clean the appliance.
Do not use industrial chemicals to clean the appliance.
Replace a damaged supply cord only by the manufacturer, its ser-
vice agent or similarly qualifi ed persons in order to avoid a hazard.
Do not try to repair the appliance by yourself. In case of repair
please contact our customer service.
Installation
Ensure a location which allows opening the door fully. Do not in-
stall the tumble dryer behind a lockable door, a sliding door or a
door with hinges on the opposite side of the tumble dryer door
as this limits the full opening of the tumble dryer door.
Install the appliance in a well-ventilated, dry place.
Never install the appliance outdoors in a damp place, or in an area
which may be prone to water leaks such as under or near a sink
unit. In the event of a water leak cut power supply and allow the
machine to dry naturally.
Install or use the appliance only where the temperature is above
5 °C.
Do not place the appliance directly on a carpet, or close to a wall
or furniture.
Do not expose the appliance to any frost, heat or direct sunlight
or in the near of heat sources(e.g. stoves, heaters).
Make sure that the electrical information on the rating plate
agrees with the power supply. If it does not, contact an electri-
cian.
Do not use multi-plug adapters and extension cables.
Make sure not to damage the electric cable and the plug. If dam-
aged have it replaced by an electrician.
Use a separate earthed socket for the power supply which is easy
accessible after installation. The appliance must be earthed.
Only for UK: The appliance's power cable is fi tted with 3-cord
(grounding) plug that fi ts a standard 3-cord (grounded) socket.
Never cut off or dismount the third pin (grounding). After the ap-
pliance is installed, the plug should be accessible.
6
EN