Other External Components; View Camera - Kenwood DNX9190DABS Instruction Manual

Other External Components

View Camera

NOTE
• To connect a camera, see P.99.
• To use a rear view camera, a REVERSE lead
connection is required. (P.97)
• If [Rear Camera Interruption] is active the
camera screen is displayed when you shift the
gear to the reverse (R) position.
Ñ
Display the camera screen
1
Press the [MENU]/[ ] button.
h Popup menu appears. h
2
Touch [Camera].
h View camera screen appears.
h
3
Adjust each item as follows.
To erase the caution message, touch the
screen.
3
1
Switching the View Camera *
Touch to display the camera switching keys.
It is necessary to set "Camera Assignment
Settings" beforehand. See To switch the view
camera (P.69).
2
Camera off
Touch to exit the camera screen.
3
Switching the Guideline *
Touching each time turns on or off the
guideline.
1
4
2
1
2
Autogoods "130"
Other External Components
4
Switching the Angle *
Touching each time changes camera angles.
*1 When two or more cameras of rear, front, left,
and right are connected with this unit.
*2 When CMOS-3xx series is connected with
this unit.
To switch the view camera
1 1
Touch [
].
h Camera switching keys appear left/right h
side.
2
Select a view camera you want to switch.
NOTE
• To switch to the picture other than selectable
view camera from the camera switching keys,
change the key function of except "Rear" in
[Camera Assignment Settings]. (P.70)
Ñ
Camera Setup
1
Press the [MENU]/[ ] button.
h Popup menu appears. h
2
Touch [SETUP].
h SETUP Menu screen appears. h
3
Touch [Camera].
h Camera screen appears. h
2
69
English