Controlling Audio; Controlling General Audio; Equalizer Control - Kenwood DNX8160DABS Quick Start Manual

Controlling Audio

Controlling Audio
1
Press the <MENU> button/
DNX8 DNX7
Volume knob.
DNX5 DNX3
2
Touch [Audio].
Audio screen appears.
NOTE
• For detailed operation, see Controlling Audio (P.84) in the
Instruction Manual.

Controlling General Audio

1
Touch [Fader / Balance] on the Audio screen.
2
Set each item as follows.
Adjust the right and left volume balance.
[C] [D]
Adjust the front and rear volume balance.
[R] [S]
22

Equalizer Control

1
Touch [Equalizer] on the Audio screen.
2
Touch the screen and set the Graphic Equalizer
as desired.
Gain level (boxed area)
Adjust the gain level by touching the each frequency bar.
You can select frequency bar and adjust its level by [R], [S].
Preset Select
Displays the screen to recall the preset equalizer curve.
Memory
Saves the adjusted equalizer curve to "User1" to "User4".
Initialize
The current EQ curve returns to flat.
ALL SRC
Apply the adjusted equalizer to all sources. Touch [ALL SRC]
and then touch [OK] on the confirmation screen.
Bass EXT (Bass Extend Settings)
When turned on, the frequency lower than 62.5 Hz is set to
the same gain level as 62.5 Hz.
SW Level
Adjusts the subwoofer volume.
Ñ Recall the EQ curve
1) Touch [Preset Select].
2) Select EQ curve.
NOTE
• [iPod] is available only during iPod source.
Ñ Save the EQ curve
1) Adjust the EQ curve.
2) Touch [Memory].
3) Select where to save.