Using Your Ice Maker - Frigidaire EFIC245-SS Use & Care Manual

1.
Ensure that the drain plug in the water reservoir is closed.
2. Plug the ice maker into the wall outlet.
3.
Open the side cover. Fill the water reservoir by manual or connect to home water tube.
NOTE: Do not fill above the MAX water level mark in the water reservoir.
Assemble the pipe:
home water tube
4.
Close the side cover. Press "ON/OFF" and the white indicator light will remain on.
5.
Select the small or large ice size.
6.
Ice making begins, ice will be frozen onto the evaporator fingers. Once ice making
cycle is finished, the water tray will tilt forward; The remaining water flows back to the water
reservoir and the ice cubes will drop from the fingers. In about 15-35 seconds, the water
tray will tilt backward, ice produced in previous cycle will be pushed to ice reservoir
directly and start to the next cycle.
7
The "Ice Full" indicator will light up in the LCD screen when the ice storage is full and the
ice maker will stop the ice making cycle automatically. Once the ice storage has been
emptied, the ice maker will restart its ice making function automatically.
8.
The "Water Faucet" indicator will light up when there is no more water in the water
reservoir and the ice making cycle will stop automatically. Fill water to the water
reservoir by manual or connect to the water faucet.
NOTE: Do not fill above the MAX water level mark in the water reservoir.
9.
Push the ice cube dispenser puncher button to get ice, the dispensing indicator will be on.
Note: Please put your cup below the ice cube dispenser shoot directly.
Notice: If the ice is stored in the unit for long time, the ice may freeze and stick together,
then no ice will be dispensed even the ice is full, if so, please kindly use scoop included
in the unit to break the ice first, then push the puncher button.
10.
Press the "crushed ice" , unit starts to dispense crushed ice, press it again, it will stop
crushed ice in 5 seconds.
11.
Push the puncher at left side of the unit, cold water will come out.
Note: If you need to get cold water, at least the ice making function should be turn on.
12.
When you have finished making ice, transfer the ice to a freezer.
NOTE: The ice will last in the Ice Maker for up to a 18 hour period, depending on the
ambiant temperature. Stop the ice making cycle by pressing "ON/OFF". Unplug
the unit from the wall outlet. Open the Cover and allow the Ice Maker to reach room
temperature and follow the directions in the Care and Cleaning section.
13.
If you need to take off the pipe, replace it or insert the anti drain plug, please do as follows:
Firstly take off the blue ring, then press the white ring (lock) at the outer side, at last take
out the pipe.

USING YOUR ICE MAKER

white pipe
connector
7