Table of Contents
Advertisement
PL1220 Precision Laser \ Maintenance \
Maintenance
General
Keep your machine clean. At the end of each day, clean the machine. Wood contains moisture, and if sawdust or wood
chips are not removed, they will cause rust. In general, we recommend that you only use a Teflon-based lubricant on the
saw. Regular oil attracts dust and dirt. Teflon lubricant tends to dry and has less of a tendency to accumulate dirt and saw
dust. Periodically check that all nuts and bolts are tight.
Drive belt
The drive belt should last for many years (depending on the usage) but needs to be inspected regularly for cracks, cuts and
general wear. If damage is found, replace the belt.
Bearings
All bearings are sealed for life and do not require any maintenance. If a bearing becomes faulty, replace it.
As needed
Clean Engraving Table (work surface)
·
Clean Mirror Surfaces (ONLY IF DIRTY)
·
Clean Focal Lens (ONLY IF DIRTY)
·
Check Mirror Alignment
·
Replace Laser Tube
·
Before Every Use
Clean Engraving Table (work surface)
·
Check Mirror Surfaces (CLEAN ONLY IF DIRTY)
·
Check Focal Lens (CLEAN ONLY IF DIRTY)
·
Check Air Assist System
·
Weekly (10 hours of use)
Clean Venting Pathway
·
Clean Air Assist Nozzle
·
Check belts for debris and lubrication. Lubricate if needed.
·
Check linear bearings and guides for debris and lubrication. Lubricate if needed.
·
36
Unplug Machine prior
to any maintenance
work.
Allays unplug the machine
when changing the blade,
guards, or any maintenance.
© 2020 Laguna Tools
Advertisement
Table of Contents
