Table of Contents
Advertisement
Notice:
A. The direction of rotary will influence the engraving effect, if direction
is wrong, the engraving image will reverse.
B. When you do not use rotary, don't forget set the parameters into initial,
and removed the check of "enable rotate engrave "
.
7. Equipment maintenance and repair
7.1 Daily maintenance
Equipment's working environment could not be too scurviness. If
temperature is higher than 30℃, lower than 18℃, and if there is too
much dust, with severe air pollution, then the machine could be badly
damaged, failure rate goes up steadily. Various electric parts are easily
damaged under wet environment.
7.2Water tank's change and clean（suggest to change water and clean
Advertisement
Table of Contents
