Panasonic PT-RZ470 Series Service Manual page 15

2. SELF CHECK
・ Each self check item is displayed.
SELF CHECK
MAIN : 1.00.00
NETWORK : 1.00.00
BALLAST : 230 DIGITAL LINK : 1.30.33.1
EMULATE : DEFAULT
OK INTR. 026/224
OK INTK. 041/151
OK DMD. 054/104
OK TEMP_R 036/101
OK TEMP_G 036/101
OK TEMP-B 036/101
OK WIND. 075/054/+5
OK LIGHT 200h30m / 1 ON
OK FAN 1111 11
OK PHOSPHOR WHEEL
* If check items are indicated with "NG" in red, the projector has an abnormality now.
If the projector has an abnormality in the past and operates normally now, the first self-check screen is indicates in red
with "OK". (Except fan error.)
3. MODEL
・ Set this when the A-P.C.Board is replaced.
* If you can copy EEPROM data from the old A-P.C.Board, this setting is unnecessary.
* This model setting is changed after power restart.
4. CLOG SENSOR CALIBRATION
・Calibrate the clogging sensor circuit.
Execute this after EEPROM（IC1405）/A-P.C.Board or Airflow sensor (M3-P.C.Board） is replaced.
* Refer to the "SECTION3 (ADJUSTMENT PROCEDURE)" about method.
5. DVI SELECT COMMAND
・Setting for DVI-I input terminal
DVI : Functions as a terminal for DVI input.
(When this item is selected, this terminal can be selected to Digital or Analog with DISPLAY OPTION menu.)
COMPUTER2 : Functions as a terminal for COMPUTER2 input. (Analog mode only.)
6. OSD SIZE (RZ470 only)
Set the on-screen display size.
3. 3. 2. Additional function of each menu
1. "POSITION" menu
The following one item is added.
・DVI EQUALIZER
When noise contamination to DVI input caused by long cable or external device, set this item so that the
noise decreases.
2. "ADVANCED" menu.
The following two items are added.
・FRAME LOCK
Set this item when moving picture is disturbed with RGB input.
・EB TESTPATTERN (to "EDGE BLENDING")
The test pattern for edge blending is projected.
OFF : Projecting the input signal.
1 - 7 : Projecting the internally generated test pattern.
* When the PICTURE MODE is set "DYNAMIC", it is OFF.
SUB : 1.00.00
FPGA : 0x2A
Error information is cleared after exiting from self-check mode.
INF - 8
Main, Sub microprocessor software version
Network and FPGA software version
BALLAST and DIGITAL LINK software version
Setting and Version of EMULATE
Internal air temperature check (Celsius/Fahrenheit)
Intake air temperature check (Celsius/Fahrenheit)
DMD temperature check (Celsius/Fahrenheit)
LED-R temperature check (Celsius/Fahrenheit)
LD unit temperature check (Celsius/Fahrenheit)
LED-B temperature check (Celsius/Fahrenheit)
Airflow sensor check (Sensor, AD conversion, Correction value)
Light source check (lighting accumulative time, number of times
the replacement, ON-OFF)
Fan check (1:Normal/0: Abnormal)
From the left, LD-G, LED-R, LED-B, DMD, EXHAUST, DRIVER
Phosphor wheel check