tronical TUNE PLUS Manual page 11

3
Make sure that all PCB drill holes line up with the
headstock's tuner holes. Insert the RoboHeads
through the Tuner holes.
5
Use the wrench that comes with the set to tighten
the Hex Nuts onto the RoboHeads.
The recommended torque for the Hex Nuts of the
RoboHeads is 1.5 nm - 1.65 nm (13.27 in.lbs - 14.6
in-lbs)
4
Apply the Washers and mount the Hex Nuts.
6
Now the TronicalTune PLUS is ready for string up.
11