Download Print this page

olympia electronics POWER LIGHT Series Quick Start Manual page 3

Non-maintained emergency luminaire

Advertisement

Mounting holes
Cover retaining screws
Test
On-off
charge
power
Charge
indicator
TEST
button
1. Install the included mounting accessories to hook the device from the mounting holes (fig. 1).
2. Unfasten the 4 mounting screws to remove the front plastic cover (fig. 1).
3. Make sure that the battery's cables are connected to the respective poles. Black cable to (-) pole
and red cable to (+) pole.
4. Install the included cable gland or the rubber o-ring. Pass thru the mains cable and stabilize it by
fastening the cable gland. Connect the wires to the terminal blocks L for live wire and Ν for
neutral.
5. Refit with care the front plastic cover, by fastening the 4 mounting screws (tightening torque
1Nm).
WARNING!!
After the installation has finished, charge the batteries for at least 24 hours so as to obtain
the rated autonomous duration.
WARRANTY
Olympia Electronics guarantees the quality, condition and operation of the goods. The period of
warranty is specified in the official catalogue of Olympia Electronics and also in the technical leaflet,
which accompanies each product. This warranty ceases to exist if the buyer does not follow the
technical instructions included in official documents given by Olympia Electronics or if the buyer
modifies the goods provided or has any repairs or re-setting done by a third party, unless Olympia
Electronics has fully agreed to them in writing. Products that have been damaged can be returned to
the premises of our company for repair or replacement, as long as the warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge
the buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or
not the buyer the transportation cost.
HEAD OFFICE
72
km. O.N.R. Thessaloniki-Katerini
nd
P.C. 60300 P.O. Box 06 Εginio Pierias Greece
www.olympia-electronics.gr
info@olympia-electronics.gr
Page 3 from 3
INSTALLATION PROCEDURE (For wall mounting only)
Fig. 1
Power
indicator
4
3
L
N
923022100_09_006

Advertisement

loading

This manual is also suitable for:

Grl-22