Advertisement
2. The device must be connected to the
mains power supply thru a fuse dependent by
the total amount of the line's power load.
3. It is sugested to check every month the
indication LED for battery charging, and by
pushing instantly the TEST button to check
the emergency cirquit and the lamps. If the
luminaire does not light
4. It is sugested to check every 6 months the
m i n i m u m a u t o n o n o u s d u r a t i o n b y
disconnecting the mains power supply. Count
the time that the lamps light and in case of
less time than the minimum autonomous
duration the batteries must be replaced. If the
measured time is considerably less than the
minimum autonomous duration
installer.
The replacement of the battery and
the light source must be done using parts of
the same type, by the manufacturer or by a
competent person.
NOTE: LED= Light Emitting Diode
LABELING EXPLANATION:
X: Self contained
0: Non Maintained (*)
A: Including test device
G: Internally illuminated
600:10 hours duration
(*) Non Maintained operation: The luminaire lights its illumination source, only in power supply's
failure.
Maintained operation: The luminaire lights its illumination source, when it is powered by the mains
power supply or not.
The light source contained in this luminaire shall only be replaced by the manufacturer, or his
agent, or a similar qualified person.
NOTE! The light source is non-user replaceable.
Manufacturer
Model Number
Voltage Range
Nominal Power
Connections
Temperature (tc)
Page 2 from 2
contact the installer.
contact the
Note!! The installer should fill in, on the specification label,
the letter G if the luminaire is used as a safety sign.
X 0
ΧΑΡΑΚΤΗΡΙΣΤΙΚΑ LED
Cable connection between main pcb and led module
5.
In case of inactive use for a period greater
than 2 months, disconnect the battery by
pulling out the battery's connector.
6. I s not allowed to discard batteries in to
t i
c o m m o n t r a s h b i n s , t h e y m u s t b e
discarded only
points. Do not incinerate.
Battery replacement.
It can be done only by a competent person
and after the mains interruption.
1. Follow the step 2 of the installation
procedure.
2. Disconnect the cables and remove the old
battery.
3. Connect the new battery with the same type
(step 3 of the installation procedure) and place
it in the position of the old one.
4. Follow the step 5 of the installation
procedure and power the device..
A G
6
0 0
GRL-22
Olympia Electronics Α.Ε.
3011129
20.3-25.2V
5.46W
50 °C max. across the board
in battery recycling
923022100_09_006
Advertisement
