olympia electronics POWER LIGHT Series Quick Start Manual

GRL-22
``POWER LIGHT`` SERIES NON-MAINTAINED EMERGENCY LUMINAIRE
TECHNICAL CHARACTERISTICS
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERY (Pb)
BATTERY PROTECTION
INDICATIONS - CONTROLS
CHARGING TIME
MINIMUM AUTONOMOUS DURATION
LIGHT SOURCE
EMERGENCY ILLUMINATION
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIALS
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
GENERAL
These luminaires are used indoors (ta 40 C)
where emergency light is needed. Each
luminaire must be permanently connected to
mains power supply. In normal operation the
power indicator lights and the charge indicator
blinks to show that the batteries are in
charging condition. In
power supply failure
charge indicators turns off and the luminaire
will light the spot lamps automatically in
emergency mode. When the mains power
supply is restored the device turns to normal
operation.
INSTALLATION
To install the luminaire follow the installation
instructions οn page 3.
OPERATION
When the device is powered from the mains,
the charge indicator blinks and confirms the
charging of the batteries. When the batteries
are charged, it lights constantly. If it does not
light, probably, the batteries are disconnected.
If it does not light and the batteries are
connected, then contact the technician. As
long as the charge indicator blinks, the
batteries of the luminaire are charging and in
this period, any autonomy test must be
Page 1 from 3
EN 60598-1, EN 60598-2-22, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3
Thank you for your trust in our products
Olympia Electronics - European manufacturer
case of a mains
the power and the
(for LED MODULE Specs. see page 2)
220-240V AC/50-60Hz
12V/7Ah
From overcharge and deep discharge
Power indicator, battery charge indicator, TEST button
600 min
White LEDs
710lm
5 to 40 C
Up to 95%
Bayblend FR3010, transparent polycarbonate
302 x 103 x 230 mm
3400gr.
3 years (1 year for the battery)
avoided. When
o
complete, the indicator lights continuously (it
can be used as an indication of a power
interruption). The batteries charging is done
by an 3 stages
technological advanced procedure, to ensure
the appropriate and full charging of the
batteries.
The power indicator confirms the proper
connection to the mains. The TEST button,
has a dual use. If pressed instantlly while the
device is connected to the mains, the device
simulates the power interruption, by lighting
the lamps for 3''. In this way, we can control
the driver circuit of the lamps and the lamps as
indicated in paragraph 3 in the text below.
Dimming option
When the voltage is interrupted, with
corresponding pressings of the button, we can
choose the illumination of 100%, 50%, 33% or
turned off, either to increase the autonomy time
or not to consume the battery power
unnecessarily. This option is canceled when the
network is restored.
ΑΤΤΕΝΤΙΟΝ!!!
1. Operations for installation, maintainance or
testing must be done by authorized personel
only.
16VA
<24h
IP42
o
the charging
923022100_09_006
circle is