Advertisement
To attach cables to a module:
1.
Fasten the locking S-Video plugs from the source and destination devices onto
the S-Video connectors (FIG. 4 previous page).
2.
Plug the power cord into the power jack on the module and the power source
(FIG. 5).
From source
Power
FIG. 5
Attach power cord and S-Video connectors
3.
Apply power to the source and destination devices.
To attach cables to an AF-10:
1.
Fasten the locking S-Video plugs from the source and destination devices onto
the S-Video connectors (FIG. 4 previous page).
FIG. 6
Attach S-Video cables onto connectors
2.
Plug the power cord into the power jack on the rear of the AF-10 and the power
source.
3.
Turn on power source.
The Power Indicator on the front of the AF-10 illuminates.
S-Video Board Placement
Note: For instructions on installing additional boards, see the AF-10
Quick Start Guide.
•
1:4 boards only – may be placed in AF-10 in any available slot
•
1:4 and 5-out boards – place in AF-10 in alternating board slots
according to the pattern below
To place S-Video 1:4 & 5-out boards in an AF-10:
Install the 1:4 board in an even numbered board slot (counting from left to right).
Install the 5-out board in the adjoining slot to the left of the 1:4 board. The input on
the 1:4 board will then route signals to its own four outputs plus the five outputs on
the 5-out board for a total of nine outputs.
1:4 boards in even-numbered slots
5-out boards to the left of 1:4 boards in odd-numbered slots
FIG. 7
Install 1:4 boards & 5-out boards in adjoining slot pairs
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
To destinations
To destinations
From source
For full warranty information, refer to www.amx.com
©2007 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
7/07
93-40-819
REV: A1
Advertisement
