Advertisement
Connecting the terminal block
Luminaire
Figure 1
Plastic base
Reflector
Diffusor
1 Pass through the central hole of the plastic base the luminaire's cables and connect them to the
included terminal block (figure 1). Ν for neutral, L for live wire.
2 Use the included mounting accessories to install the plastic base (install the notch, facing the
required direction of the luminaire) and follow the mounting methods on the wall or ceiling.
3 Install the luminaire to the plastic base by turning it clockwise by 90 and then power it, with the
mains power supply.
NOTE!! After finishing the installation you must power the luminaire at least for 24 hours for
battery charging to perform the nominal autonomy.
Page 3 from 4
INSTALLATION INSTRUCTIONS
Female terminal block
Male terminal block
Base
Mounting methods
Side view
on ceiling attached
Power supply Cable
Downside view
wall mounted
Diffusor
1
Connecting to the mains power supply
220-240V AC/50-60Hz
L
N
Brown
Blue-grey
Ν - Blue-grey
L - Brown
Figure 2: Connecting to the mains power supply
Front view
on ceiling attached
Front view
wall mounted
3
2
o
923393000_09_008
Advertisement
