Connecting The Smartlogger To The Sun8000 - Huawei SmartLogger1000 User Manual

SmartLogger1000
User Manual
Figure 4-4
Table 4-3 Connecting cables to the terminal block
Step
1
2
3
Step 5 Connect the terminal block to the COM port on the SmartLogger, as shown in
Figure 4-5 Connecting the terminal block to the SmartLogger
Step 6 Ensure that the cable is correctly connected and secured. Set Baud rate for the SUN2000 and
the SmartLogger and ensure that the parameters for these two devices are consistent.


----End
Follow-up Procedure
Take operations in reversed order to disconnect the SmartLogger from the SUN2000.

4.2.2 Connecting the SmartLogger to the SUN8000

This topic describes how to connect the SmartLogger to the SUN8000.
Context
Figure 4-6
Issue 04 (2013-12-15)
describes the operations shown in
Operation
Press the white contact plate to flip the metal spring inside the wiring terminal.
Insert the uninsulated parts of the core wires into the wiring terminals.
Let go the white contact plate to fasten the core wire.
For details about how to set the communications parameters for the SmartLogger, see
6.2.10 Setting Communications
For how to set the communications parameters for the SUN2000, see the SUN2000
(8KTL-20KTL) User Manual.
shows the RS485 wiring terminals of the SUN8000.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Table 4-3.
Parameters.
4 Electrical Connections
Figure 4-5.
26