Canon WUX500ST Quick Start Manual page 74

Troubleshooting
■ The Projector Cannot Join the Network
Cause
The LAN cable (shielded
twisted pair) is not
connected correctly.
[HDBaseT] was changed
from [On] to [Off] while
[Communication
settings] > [Wired
network] was set to
[HDBaseT].
The projector has not
been on long enough
(less than about 40
seconds).
The projector cannot join
a wireless network.
Countermeasure
Check whether the LAN cable (shielded twisted pair)
is connected to the projector correctly.
Configure the [HDBaseT] setting again as follows.
1. Change the [HDBaseT] setting from [Off] to [On]
again.
2. Change the wired network setting from [LAN port]
to [HDBaseT].
3. Following the instructions shown, press the
POWER button to enter standby mode
temporarily.
4. After at least five minutes, press the POWER
button again.
Network connections are not available until about 40
seconds after startup. Wait at least 40 seconds, and
then try to connect again.
Follow the instructions in "Network Setting",
"Wireless LAN (Wi-Fi)" (P10), and "Detailed settings
(wireless)" to set up the projector again. In PJ AP
mode, try changing the wireless channel on the
projector. In infrastructure mode, try changing the
wireless channel on the access point. If connection is
still not possible, contact the Canon Customer
Support Center.
74