Table of Contents
Advertisement
AMIFlash, Continued
Enter the filename with which Flash EPROM will be reprogrammed
(S707P.ROM). AMIFlash reads the file and displays a startup message.
Press any key to continue. After Flash programming starts, programming
activity is indicated by a rotating / character. AMIFlash informs you
when Flash programming is successful. Press any key to reboot the
system.
Errors During Flash Programming
If an error occurs during programming, an error messages is displayed
and the system halts. Turn power off and replace the Flash EPROM with a
new programmed Flash EPROM to make the system usable.
AMIFlash Messages
Save
Existing
BIOS ?
Enter
Filename:
Enter BIOS
Filename:
Programming
Flash EPROM
Saving BIOS
File in Disk
Reading BIOS
File from
Disk
Press <ESC>
to Exit
Press Any
Appendix A AMIFlash Utility
114
Message
Press Y to save the existing
BIOS.
Enter the filename in which the
existing BIOS will be saved in
the following format:
and press <Enter>.
Enter the filename with which
the Flash EPROM will be
programmed in the following
format:
and press <Enter>.
Displayed when the Flash EPROM
is being programmed.
Displayed when the existing
BIOS is saved to disk.
Displayed when the file with
which Flash EPROM will be
programmed is being read from
the disk.
When this message is displayed,
you can exit AMIFlash by
pressing <Esc>.
Usually displayed below another
Explanation
Drive:\Pathname\Filename.
Ext
Drive:\Pathname\Filename.
Ext
Advertisement
Table of Contents
