Fitting A New Door Seal; Door Latch Adjustment - Masport Bowden Wood Stacker Operating Instructions Manual

6. FITTING A NEW DOOR SEAL

This task may be easier with the door removed from the
appliance and laid horizontally on a work-bench.
1) Remove any old seal from the door.
2) Clean out the groove in the door that the seal was
bedded in using a flat-end screw driver or equivalent.
3) Run a thin bead of clear roof and gutter silicone along
the groove.
4) Starting at one end, press the new door seal into the
groove on the door.
5) Refit the door if it has been removed and close
.

7. DOOR LATCH ADJUSTMENT

Over time, the door seal can become compressed resulting in
a less than adequate seal between the door and the front
edge of the firebox. For example, if the wood burns unusually
fast even with the air slide shut, it may mean that there is an
air leak around the door.
In this situation, the door seal does not necessarily need
replacing rather adjustment of the door handle can tighten
the seal.
The latch rod on the right side of the firebox upon which the
door handle latches onto can be adjusted:
1) Loosen the barrel nut with an M8 hex key, then
loosen the M8 nut with a spanner.
2) Push the latch rod forwards towards the rear of the
heater 1-2mm. Retighten the M8 nut and the barrel
nut, taking care to not overtighten the barrel nut.
If door seal is still not tight enough replace door seal.
9