Adjusting The Door; Fitting A New Door Glass - Masport Bowden Wood Stacker Operating Instructions Manual

4. ADJUSTING THE DOOR

Over time the screws securing the door hinge plate to the
heater may loosen resulting in the door dropping, i.e. visually
appears on slight angle and no longer 100% horizontal. This
can result in a poor door seal and unnecessary amounts of
oxygen entering the firebox and wood burning too quickly.
To fix this and reposition the door:
1) With the supplied Allen key, loosen the two screws on
the hinge plate.
2) With the door 90% closed, slowly lift the bottom right
corner of the door until the door appears horizontal.
3) Keeping the door in that position relative to the hinge,
open it and tighten the screws until firm.
4) Close the door to 90% again and make any final
adjustments up or down by tapping the door on the
right hand side until it appears parallel relative to the
top and bottom surfaces of the heater.
5) Open door again and tighten screws fully.

5. FITTING A NEW DOOR GLASS

This task must be performed with the door removed from the
appliance and laid horizontally on a work-bench.
To replace the door glass:
1) Place the door glass side down on a work-bench.
Remove the 12x M6 nuts securing the glass retainers.
2) Carefully turn the door over so the frame is
resting on the bench. Pulling the four glass
retainers outwards to remove.
3) Remove the door glass panel.
4) Observe the condition of the glass rope seal, if
deteriorated replace with supplied glass seal.
5) Fit the new glass onto the door frame, with the
painted border in contact with the glass rope seal.
6) Refit the glass retainers by repeating step 1 to 2 in
reverse.
7) Dispose of the old glass in a responsible manner.
8