Table of Contents
Advertisement
10
7.
FITTING A NEW DOOR SEAL
This task may be easier with the door removed from the
appliance and laid horizontally on a work-bench.
1.
Remove any old seal from the door.
2.
Clean out the groove in the door that the seal
was bedded in using a flat-end screw driver or
equivalent.
3.
Run a thin bead of clear roof and gutter silicone
along the groove.
4.
Starting at one end, press the new door seal into
the groove on the door.
5.
Refit the door if it has been removed and close.
8.
FITTING NEW DOOR GLASS
This task must be performed with the door removed from
the appliance and laid horizontally on a work-bench.
To replace the door glass:
1.
Place the door glass side down on a work-bench.
Remove the 12x M6 nuts securing the glass
retainers.
APPLY
SILICONE
2.
Carefully turn the door over so the frame is resting
on the bench. Pulling the four glass retainers
outwards to remove.
3.
Remove the door glass panel.
4.
Observe the condition of the glass rope seal, if
deteriorated replace with supplied glass seal.
5.
Fit the new glass onto the door frame, with the
painted border in contact with the glass rope seal.
FIBREGLASS
ROPE
6.
Refit the glass retainers by repeating step 1 to 2 in
reverse.
7.
Dispose of the old glass in a responsible manner.
Advertisement
Table of Contents
