Table of Contents
Advertisement
8
3.
REMOVING THE DOOR
To remove the door:
1.
Open the door all the way.
2.
Lift the door up and over the top end of the vertical
hinge rod.
3.
Lower the door and slide off the bottom end of the
hinge rod.
4.
ADJUSTING THE DOOR HINGE
Over time the screws securing the door hinge plate to
the heater may loosen resulting in the door dropping, i.e.
visually appears on slight angle and no longer perfectly
horizontal. This can result in poor latch feel, a loose door
seal and unnecessary amounts of oxygen entering the
firebox and wood burning too quickly.
To fix this and reposition the door:
1.
With the supplied 4mm hex key, loosen the two
screws on the hinge plate.
2.
With the door 90% closed, slowly lift the bottom
right corner of the door until the door is horizontal.
3.
Keeping the door in that position relative to the
hinge, open it and tighten the screws until firm.
4.
Close the door to 90% again and make any final
adjustments up or down by tapping the door on
the right hand side until it appears parallel relative
to the top and bottom surfaces of the heater.
5.
Open door again and tighten screws fully.
Advertisement
Table of Contents
