Kohler Englefield EVORA Back-to-Wall Installation Instructions Manual page 5

EVORA
Back-to-Wall Toilet Suite
TM
CISTERN INSTALLATION - BOTTOM INLET
1
Remove the Side Inlet valve and 250mm hose.
2
Install the Bottom Inlet valve to the cistern. Discard the bung. Place
the washers over the fixing screws and locate in cistern fixing holes.
Bottom
Inlet
Valve
Washer
Seal
Nut
3
Position the cistern on the pan
by centering the gasket on the
pan inlet. Securely tighten the
screws so the cistern is level.
5
Connect the supply hose to the shut-off valve to test the system
for leaks. Shut off the water supply and disconnect the hose. Insert a
capping plug into the unused hole.
Gasket
Screw
Pan Inlet
INSTALLATION INSTRUCTIONS
Fixing Screw
Washer
Rubber Seal
Captivated Nut
(in pan)
4
Connect the supply hose to
the cistern inlet and feed the
hose through the appropriate
side hole in the pan.
Capping Plug
5 4
Skip this page if installing a
Top Rear Entry cistern configuration.
NOTE:
Bottom Inlet Valve
has been preset to
deliver a full flush
volume of 4.5L.
Side Entry Holes
Water Supply Hose
(Not supplied)
ENGLEFIELD ENGLEFIELD