Isa Nmi Messages - American Megatrends EZ-Flex User Manual

EISA Error Messages
An EISA BIOS can generate additional error messages.
Error Message
EISA CMOS Checksum
Failure
EISA CMOS inoperational
Expansion Board not
ready at Slot X, Y, Z
Fail-Safe Timer NMI
Inoperational
ID information mismatch
for Slot X, Y, Z.
Invalid Configuration
Information for Slot X, Y,
Z.
Software Port NMI
Inoperational

ISA NMI Messages

The AMI EZ-Flex EISA BIOS may generate ISA-
compatible NMI messages. The ISA NMI messages are:
ISA NMI Message
Memory Parity Error at
xxxxx
I/O Card Parity Error at
xxxxx
DMA Bus Time-out
Chapter 5 AMI BIOS POST
56
Explanation
The Checksum for EISA CMOS is incorrect. The battery
for EISA CMOS RAM may need to be replaced.
A Read/Write error occurred in extended CMOS RAM.
The battery may need to be replaced.
The BIOS cannot find the adapter card in Slot X, Y, or Z.
Make sure the board is in the correct slot and is correctly
seated.
Devices that depend on the fail-safe NMI timer do not
operate correctly.
The ID of the EISA Adapter Card in Slot X, Y, or Z does
not match the ID in EISA CMOS RAM.
The configuration information for EISA Adapter Cards X,
Y, or Z is not correct. The board cannot be configured.
Run the ECU.
The software port NMI is not working.
Explanation
Memory failed. If the memory location can be
determined, it is displayed as xxxxx. If not, the message
is Memory Parity Error ????.
An adapter card failed. If the address can be determined,
it is displayed as xxxxx. If not, the message is I/O Card
Parity Error ????.
A device drove the bus signal for more than 7.8
microseconds.