Table of Contents
Advertisement
Reprogramming from System Boot,
Beep Codes
During normal operation, the Flash utility produces a series of beeps to:
•
signify completion of a step (as shown on the previous page), or to
•
signal an error.
Error beeps are arranged in a coded sequence and have different meanings depending on when they occur. The
following list describes the error beep codes and when they can occur.
Appendix A AMIFlash Utility
88
Continued
Step
Beeps
—
None
Successful completion.
1
Continuous Single
There is no floppy disk in Drive A:.
Beep
2
Five Beeps
S701P.ROM is not present in the root directory of
the floppy disk in the A: drive.
3
Seven Beeps
Floppy Read Error.
4
Six Beeps
BIOS File Size Error.
5
Eight Beeps
An Intel i28F001BX-T Flash EPROM is not
present.
6
Continuous Two
There is a problem in erasing the Flash EPROM.
Beeps
7
Continuous Three
There is a problem in programming the Flash
Beeps
EPROM.
9
Continuous Four
The BIOS is not able to reset the CPU.
Beeps
Description
Advertisement
Table of Contents
