Table of Contents
Advertisement
SYMBOLOGY
Volts
Direct Current
Alternating Current
Amps
Hertz
Do not stare at the operating light
source.
Double insulated
Do not step or stand.
AC Power
Universal serial bus (USB)
USB power button
T3.15A
Time lag fuse
Read operator's manual
Do not dispose of electric tools
together
material. Electric tools and electronic
equipment that have reached the end
of
their
separately
environmentally compatible recycling
facility.
Regulatory Compliance Mark (RCM).
This product meets applicable
regulatory requirements.
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For
specific
charging
operator's manual supplied with your charger
and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove battery pack before
WARNING
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use
WARNING
reco
mmended
may be hazardous.
with
household
life
must
be
collected
and
returned
to
instructions,
read
accessorie
s
for thi
s tool. Others
CAUTION
1. Insert battery pack or connect to AC power.
2. Press the power
3. Press the brightness
High, Medium, and Low.
4. Press the MODE button to select full lighting, main
light, or front/back lights.
5. Press the power
NOTE: The light will default to the selected
brightness and selected mode setting the next time
it is turned on. On battery power, the light will flash
to indicate the battery is reaching end-of-charge.
To rotate the main light, pull the light outward and
rotate up to 210° counterclockwise or 95°
clockwise.To rotate the front and back lights, pull
the lights outward and rotate up to 30° counter-
clockwise or 300° clockwise.
waste
an
This outlet can be used to charge a cell phone,
power an MP3 player or any other device that uses
the
less that 2.1A of DC electrical current. To turn on the
USB, press the USB power
port will remain on for two hours before turning off
automatically.
NOTE: Any device that uses more than 2.4A of DC
electrical current will trip a self-resetting overload
and disable the output.
4
OPERATION
To reduce the risk of injury
stare at the operating light source.
Using the Lights
button to turn on the light.
button to cycle through
button to turn OFF the light.
Rotating the Lights
USB Power Outlet
, do not
button. The USB
Advertisement
Table of Contents
