Table of Contents
Advertisement
3) Adjustment of needle bar stop position(Fig.2,Fig.3)
A. Adjust of "UP" position: When the pedal is kicked down by heel, the machine stops at "UP" position.
If the marks deviate larger than 3 mm, adjust as follows.
a.
Disconnect the plug (12 pins) of cable from the
machine head.
b.
Run the machine and stop at "UP" position.
c.
While holding the pulley, insert the "adjusting
tool" in the hole "A", then remove the tool.
B. Adjust of "Down" position: When the pedal is
"Neutral" the machine stops at "Down" position. If
the marks deviate large than 5 mm, adjust as follows.
®
a.
Disconnect the plug (12 pins) of cable from the machine head.
b.
Run the machine and stop at "Down" position.
Adjueting toll
c.
While holding the pulley, insert the "adjusting tool" in the hole "B", then remove the tool.
C. Confirm the stop operation, then set the plug (12 pings) coming from the machine head into the
receptacle.
2.CAUTIONS ON USE
-1) Lubrication (1 )(Fig.4)
Pour oil up to position "H" of the oil tank.
During operation, check the oil level periodically, and in cases
where the oil level is below position "L", replenish the oil
supply up to position "H".
Use white spindle oil.
2) Lubrication (2)(Fig.5)
When a new sewing machine is used for the first time, or sewing machine left out of use for a long time is
used again, replenish a suitable amount of oil to the portions indicated by arrow in the fig.
Note: Lubricate the Hook Base everyday.
3) Adjustment of
oiling to rotating
hook( Fig.6)
- 2 -
Advertisement
Table of Contents
