Operation - Makita HM1511 Instruction Manual

2. Attach the hose holder (C) to the cord guard.
► 1. Cord guard 2. Hose holder (C)
3. Attach the dust cover and the hose to the tool, and
then fix the hose to the hose holders.
► 1. Dust cover 2. Hose 3. Hose holder (A) 4. Hose
holder (C)
4. Connect the hose to the hose of the vacuum
cleaner with the hose joint.
NOTE: If the hose is not included, attach the dust
cover to the cleaner's joint or attach it to Makita's
hose ø28.
5. Adjust the distance between the dust cover and
the tip of the chisel or bull point.
For the self sharpening bull point, adjust the dust cover
not to veil the grooves of the self sharpening bull point.
For the bits other than the self sharpening bull point, the
2 recommended distance is 30 mm to 100 mm.
1
► 1. Groove 2. 30 mm to 100 mm

OPERATION

CAUTION:
handle) and firmly hold the tool by both side grip
4
and switch handle during operations.
CAUTION:
3
piece is secured before operation. Failure to prop-
erly secure the workpiece may cause the workpiece
2
to move resulting in injury.
CAUTION:
1
even the bit gets stuck. Loss of control may
cause injury.
CAUTION:
the workpiece. Otherwise the tool may starts unin-
tentionally and cause an injury.
Chipping/Scaling/Demolition
Hold the tool firmly with both hands. Turn the tool on
and apply slight pressure on the tool so that the tool will
not bounce around, uncontrolled. Pressing very hard on
the tool will not increase the efficiency.
7 ENGLISH
1
Always use the side grip (auxiliary
Always make sure that the work-
Do not pull the tool out forcibly
Do not leave the tool stabbed in
2